Epson R200 - Stylus Photo Color Inkjet Printer Service Manual page 58

EPSON Stylus Photo R200/R210
o
When lifting up "Printer Mechanism", "Lever, Change" and
"Combination Gear, 27.2, 19.2" may detach and drop. Take care
not to drop and damage them.
o
When lifting up "Printer Mechanism", take care not to leak and
drip ink from the end of "Waste Ink Tube" ("Waste Ink Pads"
side).
o
To prevent "Frame, Main" from warping, do not lift "Printer
Mechanism" holding the places which are not specified to hold.
When installing "Printer Mechanism" to "Housing, Lower", pass
"Waste Ink Tube" through the hook indicated in the figure below,
and securely set it in the groove, so that "Porous Pad, Ink Eject,
Upper, Support" will not float from the tube. If installed
insecurely, it may cause the ink leakage.
Porous Pad, Ink Eject, Upper, Support
Hook
Waste Ink Tube
Figure 2-31. "Waste Ink Tube" installation
DISASSEMBLY AND ASSEMBLY
o
When reinstalling "Printer Mechanism",
n
For this printer, "Housing, Lower" is the standard to
correctly install each part of "Printer Mechanism".
In order to ensure the accuracy for installing, it is necessary
to manage the reference position for "Frame, Main"
installation in X, Y and Z direction as shown in the figure
below. If every part is set correctly, "Printer Mechanism"
can be secured with the hooks (x4).
[X-axis direction]
• Make sure that "Frame, Main" is installed correctly to the
groove of "Housing, Lower".
• Make sure that there is no gap between "Frame, Main"
and "Housing, Lower".
[Y-axis direction]
Make sure that the slot of "Frame, Main" is correctly
installed to the projection of "Housing, lower".
[Z-axis direction]
• Make sure that there is no gap between "Frame, Main"
and "Housing, Lower"
• Make sure that the left side of "Printer Mechanism" is
correctly secured with the hooks (x2).
Left
Figure 2-32. Reference position for "Frame, Main" installation
Disassembly
Revision A
Hooks
X-axis : (4 points)
Y-axis : (1 point)
Z-axis : (4 points)
Right
Hooks
58