5024-001
Fuser Connector Removal
1. Remove the fuser unit. See
page
4-93, for more information.
2. Remove the side cover (L). See
page
4-10, for more information.
3. Remove the shield case A assembly. See
(Low Voltage Power Supply - LVPS) Removal" on page
for more information.
4. Remove the connector (HP/HN) from the power supply unit.
5. Remove the connector to the fuser connector (for signal).
6. Remove the set screws ST4X10 (2) from the fuser connector.
7. Remove the fuser connector.
The set screw to the fuser connector is unique.
4-90
Service Manual
"Fuser Unit Removal" on
"Side Cover (L) Removal" on
"Power Supply Unit
4-30,