Setting Configuration Id - Lexmark C720 Service Manual

5024-001
The serial number will be XXXXXXXX (8 digit string)
Where X=A to Z, or 0 to 9.
If you replace the main engine (MCTL P.W.B.) Board, the serial
number needs to be identified from the serial number label on the
printer.

Setting Configuration ID

The configuration ID is used to communicate information about
certain areas of the printer that cannot be determined using
hardware sensors. The configuration ID is originally set at the
factory when the printer is manufactured, however it requires
resetting whenever you replace the controller board and can be set
on the operator panel. However, the configuration ID is the only
diagnostic function displayed until a valid ID is entered.
CONFIG IDs to be used for the 5024-001 printer:
•
000000 ID set when the operator panel is to support
850 + Katakana and not allow the power saver to be reset.
•
100001 ID set when the operator panel is to support
850 + Katakana and allow the power saver to be reset.
•
000088 ID set when the operator panel is to support
850 + NLS and not allow the power saver to be reset.
•
100089 ID set when the operator panel is to support
850 + NLS and allow the power saver to be reset.
To set the configuration ID:
1. Enter diagnostics mode, see
2. Select Configuration ID from the printer setup menu.
The current ID displays on the screen. The display should show
one of the IDs from the above list. The leftmost digit blinks
indicating that it is the first digit to be changed.
3. Press either Menu> or <Menu to change to the value you want
appears.
4. Press Select to move to the next digit, or press Select again to
skip a digit.
Change each digit as required.
"Diagnostic Mode" on page
Diagnostic Aids
3-5.
3-17