5024-001
IOD2 P.W.B. Removal
1. Remove the side cover (R). See
page
4-8, for more information.
2. Remove all harness connectors to the IOD2 P.W.B. (16).
3. Remove the fixing screws ST3X6 (5) from the IOD2 P.W.B.
4. Remove the IOD2 P.W.B. from the base.
After performing the reverse removal steps:
1. Reconnect the power supply cable.
2. Turn the printer On.
3. Execute the test print in the service mode. See
Mode" on page
4. Confirm printer operation and print quality.
4-28
Service Manual
3-5, for more information.
"Side Cover (R) Removal" on
"Diagnostic