Setting Configuration Id - Lexmark T520 - 20ppm 8MB Par USB Pcl6 Ps3 Ppds Service Manual

4520-xxx

Setting Configuration ID

The configuration ID is used to communicate information about
certain areas of the printer that cannot be determined using
hardware sensors. The Configuration ID is originally set at the
factory when the printer is manufactured, however it requires
resetting whenever you replace the engine board and can be set on
the operator panel. However the Configuration ID is the only
diagnostic function displayed until a valid ID is entered.
To set the Configuration ID:
1. Enter the Diagnostic mode.
2. Select Configuration ID from the Printer Setup menu.
•
The current ID displays on the screen. The Configuration ID
is on a label located inside the printer. The label is attached
to the top front cover hinge assembly and is visible when the
top front cover is open.
•
The leftmost digit blinks indicating that it is the first digit to be
changed.
3. To change the value, press either Menu until the value you want
is reached. Press Select to move to the next digit, or press
Select again to skip a digit. Change each digit as required.
When the last digit is changed, press Select to validate the
Configuration ID. If the ID is invalid then "INVALID ID" message
displays on Line 2 before the ID redisplays. You have to reenter
the Configuration ID until a valid ID is verified. If the ID is valid
then the ID is saved in NVRAM and the printer automatically
PORs to activate the new setting.
Note: When the printer PORs it does so in the normal mode.
3-20
Service Manual