Restrictions On Job Parameter Modification - Xerox 6100BD - Phaser Color Laser Printer Software Manual

Using Dynamic Job Descriptor Entries (DJDEs)

Restrictions on job parameter modification

Parameters that
cannot be
changed through a
JDE DJDE
5-6
To process a DJDE, the system must process data up to the
recognition and interpretation of the DJDE itself. This sequence
requires that the basic description of the input source must be
correct before the application of the DJDE. Therefore, you must
not change the description of the input source with DJDEs, either
by accident or by intent.
The system also does not allow certain basic parameters to be
changed through the selected JDE (the JDE specified by the
JDE DJDE).
NOTE: CODE changes to data may occur and take effect on the
page boundary following the DJDE record. If a translation code
change is involved in a selected JDE, the parameter portion of
any subsequent DJDE must be in the new code. The prefix used
by the IDEN must, however, retain the original hexadecimal
value. Thus, if the CODE changes from EBCDIC to ASCII, the
prefix must remain in EBCDIC even though the parameter
portion changes to ASCII.
The parameters that cannot be changed through a JDE that is
specified in the JDE DJDE are listed in the following table.
Table 5-1. Parameters that are not changeable by a JDE
DJDE
Command Parameters
BANNER All parameters
BLOCK All parameters
IDEN All parameters except OPRINFO
OUTPUT OFFSET
RECORD All parameters except LENGTH
VOLUME HOST
Using LCDS Print Description Language