Output Format - Xerox 6100BD - Phaser Color Laser Printer Software Manual

OUTPUT FEED
parameter: points
to note
Syntax
Options
Table 4-54. OUTPUT FORMAT parameter options and definitions
Option
pdeid
Default

OUTPUT FORMAT

parameter: point
to note
Using LCDS Print Description Language
• "FEED = stockreference" must refer to a stock assigned to a
stockname by the STOCKSET command that has been
specified for the report.
• The MAIN stock is the default for system generated pages
and is used if no SYSPAGE stock is specified.
• The FreeFlow Print Server LCDS software comes with MAIN,
AUX, and AUTO stocks defined.
• If the OUTPUT FEED command and the RAUX command
specify two different stock names, RAUX has higher priority.
• The 'stockname' option bypasses the stock reference
feature, but it still requires that the stock name be specified in
the current STOCKSET command. (FEED=stockreference is
the recommended usage.)
OUTPUT FORMAT
Specifies a page descriptor entry (PDE) to be used in formatting
the printed output, such as location of starting print line for each
logical page on the physical page, font usage, and orientation.
OUTPUT FORMAT = pdeid
NOTE: To ensure readability, enter the entire parameter
FORMAT. Do not abbreviate to "FOR."
Definition
page descriptor entry identifier
References a page descriptor entry that was either defined previously in the
JDL or catalogued as a separate file in the "lcds" resources folder on disk.
Refer to "Coding a JSL" in the "PDL principles and procedures" chapter for
information on creating and compiling PDE files using the XJDC processor.
FMT1
Standard pdeids, such as FMT1 and FMT2, are defined in the
"PDE command" section, later in this chapter. These standard
PDEs are delivered with the printing system software and may
be used unless a specialized PDE is required. The choice of
active PDE may subsequently be replaced entirely or modified in
part through DJDEs.
Specifying print format parameters
4-55