Criteria Constant - Xerox 6100BD - Phaser Color Laser Printer Software Manual

Using logical processing
CRITERIA
CHANGE
parameter syntax
example
Syntax
3-16
– If the LINENUM parameter is used, lines within the
specified range are processed normally, and lines outside
the range are not evaluated. Thus, Change mode
comparison strings are not saved from lines outside of a
LINENUM range. Refer to the "CRITERIA LINENUM"
parameter section in this chapter for information on using
this parameter of the CRITERIA command.
– "No print" records (carriage control specifies no printing
but only skipping or spacing) are evaluated for logical
processing.
A Change mode CRITERIA command can be coded as follows:
criid: CRITERIA CHANGE= (offset, length, NE, LAST),
LINENUM= (init, count);

CRITERIA CONSTANT

Specifies that the content of a record will be compared to the
values that were specified in a TABLE command with the
identifier tabid. The CRITERIA CONSTANT specification is
referenced by the TEST parameter of the logical processing
command that follows it in the JSL.
CONSTANT also specifies the location and length of the fixed
field within a record that will be searched for the constant. The
field to be compared is located the number of bytes indicated by
the offset variable from the start of the user portion of the record.
The field has a length the number of bytes indicated in the length
variable.
When the field in the record matches a constant in the table and
is equal (EQ), the CRITERIA command is TRUE, and the
processing that was specified by the parameter is performed. If
the field matches a constant in the table, but is not equal (NE),
the command is FALSE.
ac: CRITERIA CONSTANT = (offset, length, {EQ | NE}, tabid)
Using LCDS Print Description Language