Permit (Management) - HP BladeSystem bc2000 - Blade PC Reference Manual

permit (Management)

The permit Management Access-List Configuration mode command defines a permit rule.
Syntax
permit [ethernet interface-number | vlan vlan-id | port-channel port-channel-number] [service
service]
permit ip-source ip-address [mask mask | prefix-length] [ethernet interface-number | vlan
port-channel
vlan-id |
Parameters
interface-number — A valid Ethernet port number.
n
vlan-id — A valid VLAN number.
n
port-channel-number — A valid port channel index.
n
ip-address — A valid source IP address.
n
mask — A valid network mask of the source IP address.
n
prefix-length — Number of bits that comprise the source IP address prefix. The prefix length
n
must be preceded by a forward slash (/). (Range: 0-32)
service — Service type. Possible values: telnet, ssh, http, https and snmp.
n
Default Setting
If no permit rule is defined, the default is set to deny
Command Mode
Management Access-list Configuration mode
Command Usage
Rules with Ethernet, VLAN and port-channel parameters are valid only if an IP address is
defined on the appropriate interface.
The system supports up to 128 management access rules.
Example
The following command permits all ports in the mlist access list.
Console(config)# management access-list mlist
Console(config-macl)# permit
HP PC Blade Switch CLI Reference Guide
port-channel-number | ] [service service]
www.hp.com
Management ACL Commands
.
14-3