Port Security Mode - HP BladeSystem bc2000 - Blade PC Reference Manual
Command line interface reference guide hp bladesystem pc blade switch
Hide thumbs
Also See for BladeSystem bc2000 - Blade PC:
- User manual (216 pages) ,
- Administrator's manual (104 pages) ,
- Setup and installation manual (104 pages)
Table of Contents
Advertisement
port security mode
The port security mode Interface Configuration mode command configures the port security
mode. To return to the default configuration, use the no form of this command.
Syntax
port security mode {lock | dynamic}
no port security mode
Parameters
lock — Saves the current dynamic MAC addresses associated with the port and disables
n
learning, relearning and aging.
dynamic — Deletes the current dynamic MAC addresses associated with the port and learns
n
up to the maximum number addresses allowed on the port. Relearning and aging are enabled.
Default Setting
This setting is disabled.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
Command Usage
There are no user guidelines for this command.
Example
In the following command, the port security mode is set to dynamic for Ethernet interface e7.
Console(config)# interface ethernet e7
Console(config-if)# port security mode dynamic
HP PC Blade Switch CLI Reference Guide
www.hp.com
Address Table Commands
5-1 1
Advertisement
Table of Contents
