Sntp Client Enable (Interface) - HP BladeSystem bc2000 - Blade PC Reference Manual
Command line interface reference guide hp bladesystem pc blade switch
Hide thumbs
Also See for BladeSystem bc2000 - Blade PC:
- User manual (216 pages) ,
- Administrator's manual (104 pages) ,
- Setup and installation manual (104 pages)
Table of Contents
Advertisement
Clock Commands
sntp client enable (Interface)
The sntp client enable Interface Configuration (Ethernet, port-channel, VLAN) mode command
enables the Simple Network Time Protocol (SNTP) client on an interface. This applies to both
receive broadcast and anycast updates. To disable the SNTP client, use the no form of this
command.
Syntax
sntp client enable
no sntp client enable
Parameters
There are no parameters for this command.
Default Setting
The SNTP client is disabled on an interface.
Command Mode
Interface configuration (Ethernet, port-channel, VLAN) mode
Command Usage
Use the sntp broadcast client enable Global Configuration mode command to enable broadcast
clients globally.
Use the sntp anycast client enable Global Configuration mode command to enable anycast
clients globally.
Example
The following command enables the SNTP client on Ethernet port e3.
Console(config)# interface ethernet e3
Console(config-if)# sntp client enable
6-12
www.hp.com
HP PC Blade Switch CLI Reference Guide
Advertisement
Table of Contents
