HP BladeSystem bc2000 - Blade PC Reference Manual page 136

Ethernet Configuration Commands
The following command displays counters for Ethernet port e1:
Console# show interfaces counters ethernet e1
Port InOctets
------ -----------
e1 183892
Port OutOctets
------ -----------
e1 9188
FCS Errors: 8
Single Collision Frames: 0
Late Collisions: 0
Oversize Packets: 0
Internal MAC Rx Errors: 0
Symbol Errors: 0
Received Pause Frames: 0
Transmitted Pause Frames: 0
The following table describes the fields shown in the example.
Field
InOctets
InUcastPkts
InMcastPkts
InBcastPkts
OutOctets
OutUcastPkts
OutMcastPkts
OutBcastPkts
FCS Errors
Single Collision Frames
Late Collisions
Oversize Packets
Internal MAC Rx Errors
8-18
InUcastPkts
--------------
0
OutUcastPkts
--------------
0
Description
Counted received octets.
Counted received unicast packets.
Counted received multicast packets.
Counted received broadcast packets.
Counted transmitted octets.
Counted transmitted unicast packets.
Counted transmitted multicast packets.
Counted transmitted broadcast packets.
Counted received frames that are an integral number of octets in
length but do not pass the FCS check.
Counted frames that are involved in a single collision, and are
subsequently transmitted successfully.
Number of times that a collision is detected later than one slot time
into the transmission of a packet.
Counted frames received that exceed the maximum permitted frame
size.
Counted frames for which reception fails due to an internal MAC
sublayer receive error.
www.hp.com
InMcastPkts InBcastPkts
----------- -----------
0 0
OutMcastPkts OutBcastPkts
------------ ------------
0 0
HP PC Blade Switch CLI Reference Guide