Nip Igmp Snooping Host-Time-Out - HP BladeSystem bc2000 - Blade PC Reference Manual

nip igmp snooping host-time-out

The ip igmp snooping host-time-out Interface Configuration (VLAN) mode command
configures the host-time-out. If an IGMP report for a multicast group was not received for a
host-time-out period from a specific port, this port is deleted from the member list of that
multicast group. To return to the default configuration, use the no form of this command.
Syntax
ip igmp snooping host-time-out time-out
no ip igmp snooping host-time-out
Parameters
time-out — Host timeout in seconds. (Range: 1-2147483647)
n
Default Setting
The default host-time-out is 260 seconds.
Command Mode
Interface Configuration (VLAN) mode
Command Usage
The timeout should be at least greater than 2*query_interval+max_response_time of the IGMP
router.
Example
In the following example, the host timeout is configured to 300 seconds.
Console(config)# interface vlan 2
Console(config-if)# ip igmp snooping host-time-out 300
HP PC Blade Switch CLI Reference Guide www.hp.com
IGMP Snooping Commands
10-3