Gvrp Enable (Interface) - HP BladeSystem bc2000 - Blade PC Reference Manual
Command line interface reference guide hp bladesystem pc blade switch
Hide thumbs
Also See for BladeSystem bc2000 - Blade PC:
- User manual (216 pages) ,
- Administrator's manual (104 pages) ,
- Setup and installation manual (104 pages)
Table of Contents
Advertisement
GVRP Commands
gvrp enable (Interface)
The gvrp enable Interface Configuration (Ethernet, port-channel) mode command enables
GVRP on an interface. To disable GVRP on an interface, use the no form of this command.
Syntax
gvrp enable
no gvrp enable
Parameters
There are no parameters for this command.
Default Setting
GVRP is disabled on all interfaces.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
Command Usage
An access port does not dynamically join a VLAN because it is always a member in only one
VLAN.
Membership in an untagged VLAN is propagated in the same way as in a tagged VLAN. That is,
the PVID is manually defined as the untagged VLAN VID.
Example
The following command enables GVRP on Ethernet port e45.
Console(config)# interface ethernet e45
Console(config-if)# gvrp enable
9-2
www.hp.com
HP PC Blade Switch CLI Reference Guide
Advertisement
Table of Contents
