Cr_Autolampcontrl Command; Cr_Lampsts Command; Cr_Inflamp Command; Cr_Projh Command - Sanyo PLC-HF10000L - 10000 Lumens Manual

PLC-HF10000L Expand Serial Command Functional Specifications

9.9.5 CR_AUTOLAMPCONTRL Command

Command "CR_AUTOLAMPCONTRL" [CR]
Details Get selected Lamp control mode
Acceptable
Response
%1
Unacceptable

9.9.6 CR_LAMPSTS Command

Command "CR_LAMPSTS" [CR]
Details Get the information of Lamp lighting status
Acceptable
Response
%1
Unacceptable

9.9.7 CR_INFLAMP Command

Command "CR_INFLAMP" [CR]
Details Get Lamp mode switching status
Acceptable
Response
%1
Unacceptable

9.9.8 CR_PROJH Command

Command "CR_PROJH" [CR]
Details Get total running time of projector (in hours)
Acceptable
Response
Unacceptable

9.9.9 CR_HMLAMP Command

Command "CR_HMLAMP" [CR]
Details Get total lamp number
Acceptable
Response
%1
Unacceptable
"000_%1" [CR]
"NORMAL" ---------- NORMAL is selected.
"ECO1" --------------- ECO1 is selected.
"ECO2" --------------- ECO2 is selected.
"AUTO" -------------- AUTO is selected.
"Error Code" [CR]
"000_%1" [CR]
"2**"
The first character indicates 2 lamps are used in this model.
The following characters indicate each lamp status in lamp
number order as showed below.
"I" ------------------------ Lamp is ON
"O" ---------------------- Lamp is OFF
"X" ----------------------- Lamp Failure
e.g.
"2IO" ------------------- This indicates it is 2-lamps system, Lamp
#1 is ON, and #2 is OFF.
"?" [CR]
"000_%1" [CR]
"NML" -- in Normal status (lamp switching operation is not active.)
"?" [CR]
"000_%1" [CR]
%1 "0000000" – "0099999"
"?" [CR]
"000_%1" [CR]
"002"
"?" [CR]
84/105