Pc Control Command; Cf_Fsync Command; Cf_Tdots Command; Cf_H-Pos Command - Sanyo PLC-HF10000L - 10000 Lumens Manual

PLC-HF10000L Expand Serial Command Functional Specifications

8.5 PC Control Command

8.5.1 CF_FSYNC Command

Command "CF_FSYNC_%1" [CR]
"0000-0031" ----------------- Directly specify setting value of Fine Sync
%1 "UP" --------------------------- Increment setting value of Fine Sync by 1
"DN" --------------------------- Decrement setting value of Fine Sync by 1
Set value of Fine Sync in PC signal (Available only in the normal Power ON status)
The value set by this command is not stored in the projector's memory. Therefore,
Details
when the power is turned to ALL OFF status, the value returns to the original
setting. (It is stored in Suspend mode.)
Acceptable
Response
Unacceptable

8.5.2 CF_TDOTS Command

Command "CF_TDOTS_%1" [CR]
"mmmm – nnnn" --------------- Directly specify setting value of Total Dots
"mmmm" indicates minimum value, which is current (Display Area H + Position H) value
%1 "nnnn" indicates maximum value, that dot clock does not exceed more than 160MHz.
"UP" ------------------------- Increment setting value of Total Dots by 1
"DN" ------------------------- Decrement setting value of Total Dots by 1
Set value of Total Dots in PC signal (Available only in the normal Power ON
status)
Details The value set by this command is not stored in the projector's memory. Therefore,
when the power is turned to ALL OFF status, the value returns to the original
setting. (It is stored in Suspend mode.)
Acceptable
Response
Unacceptable

8.5.3 CF_H-POS Command

Command "CF_H-POS_%1" [CR]
"0000-nnnn" -------- Directly specify setting value of Horizontal Position
%1
"nnnn" indicates maximum value, which is current value of (Total Dots – Display Area H)
"UP" ------------------- Increment setting value of Horizontal Position by 1
"DN" ------------------ Decrement setting value of Horizontal Position by 1
Set value of Horizontal Position in PC signal (Available only in the normal Power
ON status)
Details The value set by this command is not stored in the projector's memory. Therefore,
when the power is turned to ALL OFF status, the value returns to the original
setting. (It is stored in Suspend mode.)
Acceptable
Response
Unacceptable
"000" [CR]
"101" [CR] --- When input is Video signal
--- When input is no signal
"000" [CR]
"101" [CR] --- When input is Video signal
--- When input is no signal
"000" [CR]
"101" [CR] --- When input is Video signal
--- When input is no signal
28/105