Cf_Image Command; Cf_Imageadj Command - Sanyo PLC-HF10000L - 10000 Lumens Manual

PLC-HF10000L Expand Serial Command Functional Specifications

8.4.15 CF_IMAGE Command

Command "CF_IMAGE__%1" [CR]
"STAND" ----------- Standard (Image adjustment value is set to factory default)
"REAL" ------------- Real (Fixed value to display graphic image with natural tone)
"CINEMA" --------- Cinema (Fixed value to focus on tone reproduction for movie)
"DYNAMIC" --------Dynamic (Fixed value to enable projection with a sharp,
"CUSTOM1" ------ Image1 (values adjusted and stored by user)
"CUSTOM2" ------ Image2 (values adjusted and stored by user)
%1 "CUSTOM3" ------ Image3 (values adjusted and stored by user)
"CUSTOM4" ------ Image4 (values adjusted and stored by user)
"CUSTOM5" ------ Image5 (values adjusted and stored by user)
"CUSTOM6" ------ Image6 (values adjusted and stored by user)
"CUSTOM7" ------ Image7 (values adjusted and stored by user)
"CUSTOM8" ------ Image8 (values adjusted and stored by user)
"CUSTOM9" ------ Image9 (values adjusted and stored by user)
"CUSTOM10" -----Image10 (values adjusted and stored by user)
Select Image mode. (Valid only when it is in the normal Power ON status.)
Parameter "CUSTOM1" to "CUSTOM10" corresponds to "Image1" to "Image10"
Details displayed in projector OSD menu on selecting Image.
The value set by this command is stored in EEPROM so that the setting can
remain effective even after the power is turned to ALL OFF status.
Acceptable
Response
Unacceptable

8.4.16 CF_IMAGEADJ Command

Command "CF_IMAGEADJ_%1"[CR]
"RST"------ Reset adjusted value for the Image
"STR1"---- Store current adjusted value to Image 1
"STR2"---- Store current adjusted value to Image 2
"STR3"---- Store current adjusted value to Image 3
"STR4"---- Store current adjusted value to Image 4
%1
"STR5"---- Store current adjusted value to Image 5
"STR6"---- Store current adjusted value to Image 6
"STR7"---- Store current adjusted value to Image 7
"STR8"---- Store current adjusted value to Image 8
"STR9"---- Store current adjusted value to Image 9
"STR10"--- Store current adjusted value to Image 10
Reset or Store adjusted value for Image. (Available only in the normal Power ON
status)
"STR1"-"STR10" corresponds to "Image1"-"Image10" displayed in projector OSD
Details
menu on selecting "Store" for adjusted value of Image. The setting value set in
"Image1" to "Image10" is stored and can be retrieved when turning on the
projector again after the power is turned to ALL OFF status.
Acceptable
Response
Unacceptable
powerful picture tone)
"000" [CR]
"Error Code" [CR]
"000" [CR]
"Error Code" [CR]
26/105