Wds Bridge Commands - 3Com 3CRWEASYA73 User Manual

C 6: C L
HAPTER OMMAND INE
Example
Outdoor 11a Building to Building #show filters
Protocol Filter Information
=======================================================================
Local Bridge
AP Management
Ethernet Type Filter :DISABLED
UPlink Access Table
-----------------------------------------------------------------------
UPlink access control:Enabled
UPlink MAC access control list
00-12-34-56-78-9a
-----------------------------------------------------------------------
Enabled Protocol Filters
-----------------------------------------------------------------------
No protocol filters are enabled
=======================================================================
Outdoor 11a Building to Building #

WDS Bridge Commands

The commands described in this section are used to set the operation mode for
each access point interface and configure WIreless Distribution System (WDS)
forwarding table settings.
Table 22 WDS Bridge Commands
Command
bridge mode
bridge role
bridge channel-auto-sync
bridge-link parent
bridge-link child
bridge dynamic-entry
age-time
show bridge aging-time
show bridge filter-entry
show bridge link
I
NTERFACE
:Traffic among all client STAs blocked
:ENABLED
Function
Selects Master or Slave mode.
Selects the bridge operation mode for a radio interface IC-W
Automatically finds the parent bridge operating
channel
CAUTION: Do not enable Channel Auto Sync on a master
!
bridge if there is no root bridge acting as the master
bridge's parent.
Configures the MAC addresses of the parent bridge
node
Configures MAC addresses of connected child bridge
nodes
Sets the aging time for dynamic entries in the WDS
forwarding table
Displays the current WDS forwarding table aging time Exec
Displays current entries in the bridge MAC address
table
Displays current bridge settings for specified interfaces Exec
:
6-88
Mode Page
IC-W 6-89
6-89
IC-W 6-90
IC-W 6-90
IC-W 6-91
GC 6-92
6-94
Exec 6-95
6-97