Tcp Keepalive-Timeout - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

Chapter 23 T Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

tcp keepalive-timeout

To configure the interval between which the TCP connection verifies if the FCIP link is functioning, use
the tcp keepalive-timeout command. Use the no form of this command to disable this feature or revert
to its factory defaults.
Syntax Description
seconds
Defaults 60 seconds.
Command Modes FCIP profile configuration submode.
Command History Release
1.1(1)
Usage Guidelines This command can be used to detect FCIP link failures.
Examples The following example configures a FCIP profile:
switch# config terminal
switch(config)# fcip profile 5
switch(config-profile)#
The following example specifies the keepalive timeout interval for the TCP connection:
switch(config-profile)# tcp keepalive-timeout 120
Related Commands Command
fcip profile
show fcip profile
OL-18089-01, Cisco MDS NX-OS Release 4.x
tcp keepalive-timeout seconds
no tcp keepalive-timeout seconds
Modification
This command was introduced.
Description
Configures FCIP profile parameters.
Displays FCIP profile information.
Specifies the time in seconds. The range is 1 to 7200.
Cisco MDS 9000 Family Command Reference
tcp keepalive-timeout
23-27