Tape-Volgrp - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

tape-volgrp

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
tape-volgrp
To configure the crypto tape volume group, use the tape-volgrp command. To disable this command, use
the no form of the command.
Syntax Description group name
Defaults
None.
Command Modes Cisco SME crypto backup tape group configuration submode.
Command History Release
3.2(2)
Usage Guidelines
The tape volume group commands are available in the Cisco SME crypto tape volume group
(config-sme-cl-tape-bkgrp-volgrp) submode.
Examples The following example configures a crypto tape volume group:
switch# config t
switch(config))# sme cluster c1
switch(config-sme-cl)# tape-bkgrp tbg1
switch(config-sme-cl-tape-bkgrp)# tape-volgrp tv1
switch(config-sme-cl-tape-bkgrp-volgrp)#
The following example removes a crypto tape volume group.
switch# config t
switch(config)# sme cluster c1
switch(config-sme-cl)# tape-bkgrp tbg1
switch(config-sme-cl-tape-bkgrp)# no tape-volgrp tv1
Related Commands Command
show sme cluster tape
clear sme
Cisco MDS 9000 Family Command Reference
23-20
tape-volgrp group name
no tape-volgrp group name
Specifies the tape volume group name.
Modification
This command was introduced.
Description
Displays information about tapes
Clears Cisco SME configuration.
Chapter 23 T Commands
OL-18089-01, Cisco MDS NX-OS Release 4.x