Chapter 23
T Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
time-stamp
To enable FCIP time stamps on a frame, use the time-stamp command. To disable this command for the
selected interface, use the no form of the command.
Syntax Description
acceptable-diff number Configures the acceptable time difference for timestamps in milliseconds.
Defaults
Disabled.
Command Modes
Interface configuration submode.
Command History
Release
1.1(1)
Usage Guidelines
Access this command from the
The time-stamp option instructs the switch to discard frames that are older than a specified time.
Examples
The following example enables the timestamp for an FCIP interface.
switch# config terminal
switch(config)# interface fcip 50
switch(config-if)# time-stamp
switch(config-if)# time-stamp acceptable-diff 4000
Related Commands
Command
show interface fcip
OL-18089-01, Cisco MDS NX-OS Release 4.x
time-stamp [acceptable-diff number]
no time-stamp [acceptable-diff number]
The range is 500 to 10000.
Modification
This command was introduced.
Description
Displays the configuration for a specified FCIP interface.
submode.
switch(config-if)#
Cisco MDS 9000 Family Command Reference
time-stamp
23-49