Target (Islb Initiator Configuration) - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual
Cisco mds 9000 family command reference guide - release 4.x (ol-18089-01, february 2009)
Hide thumbs
Also See for AJ732A - Cisco MDS 9134 Fabric Switch:
- Configuration manual (700 pages) ,
- Messages manual (518 pages) ,
- Installation manual (288 pages)
Table of Contents
Advertisement
Chapter 23
T Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
target (iSLB initiator configuration)
To configure an iSLB initiator target, use the target command in iSLB initiator configuration submode.
To remove the target configuration, use the no form of the command.
Syntax Description
device-alias
device-alias
pwwn pWWN
vsan
vsan-id
no-zone
trespass
revert-primary-port
fc-lun LUN
iscsi-lun LUN
sec-device-alias
target-device-alias
sec-pwwn pWWN
sec-vsan
sec-vsan-id
sec-lun LUN
OL-18089-01, Cisco MDS NX-OS Release 4.x
target {device-alias device-alias | pwwn pWWN}
[vsan vsan-id]
[no-zone]
[trespass]
[revert-primary-port]
[fc-lun LUN iscsi-lun LUN]
[sec-device-alias device-alias | sec-pwwn pWWN]
[sec-vsan sec-vsan-id]
[sec-lun LUN]
[iqn-name target-name]
no target {device-alias device-alias | pwwn pWWN}
[vsan vsan-id]
[no-zone]
[trespass]
[revert-primary-port]
[fc-lun LUN iscsi-lun LUN]
[sec-device-alias device-alias | sec-pwwn pWWN]
[sec-vsan sec-vsan-id]
[sec-lun LUN]
[iqn-name target-name]
Specifies the device alias of the Fibre Channel target.
Specifies the pWWN of the Fibre Channel target. The format is
hh:hh:hh:hh:hh:hh:hh:hh.
Assigns VSAN membership to the initiator target.
Specifies the VSAN ID. The range is 1 to 4093.
Indicates no automatic zoning.
Enables trespass support.
Reverts to the primary port when it comes back up.
Specifies the Fibre Channel LUN of the Fibre Channel target. The format is
0xhhhh[:hhhh[:hhhh[:hhhh]]]
Specifies the iSCSI LUN. The format is 0xhhhh[:hhhh[:hhhh[:hhhh]]].
Specifies the device alias of the secondary Fibre Channel target.
Specifies the initiator's target device alias. The maximum size is 64.
Specifies the pWWN of the secondary Fibre Channel target. The format is
hh:hh:hh:hh:hh:hh:hh:hh.
Assigns VSAN membership to the initiator.
Specifies the VSAN ID. The range is 1 to 4093.
Specifies the FC LUN of the secondary Fibre Channel target. The format is
0xhhhh[:hhhh[:hhhh[:hhhh]]].
target (iSLB initiator configuration)
Cisco MDS 9000 Family Command Reference
23-23
Advertisement
Table of Contents
