Scheduler - Garmin G900X Pilot's Manual

ADDITIONAL FEATURES

8.8 SCHEDULER

The Scheduler feature can be used to enter and display reminder messages (e.g., Change oil, Altimeter-
Transponder, or Hot Section Inspection or Phase 1 Maintenance Check) in the Messages Window on the PFD.
Messages can be set to display based on a specific date and time (event), once the message timer reaches zero
(one-time; default setting), or recurrently whenever the message timer reaches zero (periodic). Message timers set
to periodic alerting automatically reset to the original timer value once the message is displayed. When power is
cycled, all messages are retained until deleted, and message timer countdown is resumed.
Entering a scheduler message:
1) Select the AUX - Utility Page.
2) Press the FMS Knob momentarily to activate the flashing cursor.
3) Turn the large FMS Knob to highlight the first empty scheduler message naming field.
4) Use the FMS Knob to enter the message text to be displayed in the Messages Window and press the ENT
Key.
5) Press the ENT Key again or use the large FMS Knob to move the cursor to the field next to Type.
6) Turn the small FMS Knob to select the message type:
• Event—Message issued at the specified date/time
• One-time—Message issued when the message timer reaches zero (default setting)
• Periodic—Message issued each time the message timer reaches zero
7) Press the ENT Key again or use the large FMS Knob to move the cursor to the next field.
8) For periodic and one-time message, use the FMS Knob to enter the timer value (HH:MM:SS) from which to
countdown and press the ENT Key.
622
Figure 8-98 Scheduler (Utility Page)
Garmin G900X Pilot's Guide
190-00726-00 Rev. J