Dme Tuning - Garmin G900X Pilot's Manual

AUDIO PANEL AND CNS

DME TUNING

When another auxiliary window is turned on, the DME Tuning Window is replaced on the PFD.
NOTE:
When turning on the G900X for use, the system remembers the last frequency used for DME tuning
NOTE:
and the NAV1 NAV2, or HOLD state prior to shutdown.
,
The G900X System tunes the optional DME transceiver. Tune the UHF DME frequency by pairing with a
VHF NAV frequency. DME frequency pairing is automatic and only the VHF NAV frequency is shown.
The DME Tuning Window is located to the right of the HSI in the lower right corner of the PFD. Select NAV1,
NAV2, or HOLD in the DME Tuning Window to tune the DME transceiver. Pressing the DME Softkey shows
or hides the DME Tuning Window.
The following DME transceiver pairings can be selected:
• NAV1 – Pairs the DME frequency from the selected NAV1 frequency.
• NAV2 – Pairs the DME frequency from the selected NAV2 frequency.
• HOLD – When in the HOLD position, the DME frequency remains paired with the last selected NAV
frequency.
Selecting DME transceiver pairing:
1) Press the DME Softkey to display the DME Tuning Window.
2) Turn the small FMS Knob to select the DME tuning mode.
3) Press the ENT Key to complete the selection.
Pressing the CLR Key or FMS Knob while in the process of DME pairing cancels the tuning entry and reverts
back to the previously selected DME tuning state. Pressing the FMS Knob activates/deactivates the cursor in
the DME Tuning Window.
See the Flight Instruments Section for displaying the DME information window.
160
Figure 4-35 DME Tuning Window
Garmin G900X Pilot's Guide
DME
Modes
190-00726-00 Rev. J