System Status - Garmin G900X Pilot's Manual

SYSTEM STATUS

The G900X performs an automatic test of TIS during power-up. If TIS passes the test, TIS enters Standby
Mode (on the ground) or Operating Mode (in the air). If TIS fails the power up test, an annunciation is shown
in the center of the Traffic Map Page.
TIS System Failed
No Data Received
from Transponder
The traffic mode is annunciated in the upper left corner of the Traffic Map Page. When the aircraft is on the
ground, TIS automatically enters Standby Mode. If traffic is selected for display on another map while Standby
Mode is selected, the traffic display enabled icon is crossed out (also the case whenever TIS has failed). Once
the aircraft is airborne, TIS switches to Operating Mode and traffic information is displayed. The mode can be
changed manually using softkeys or the page menu.
190-00726-00 Rev. J
Traffic Map Page Center
Banner Annunciation
NO DATA
Data is not being received from the transponder*
Data is being received from the transponder, but
DATA FAILED
a failure is detected in the data stream*
FAILED
The transponder has failed*
UNAVAILABLE
TIS is unavailable or out of range
* Contact a service center or Garmin dealer for corrective action
Table 6-28 TIS Failure Annunciations
Figure 6-163 TIS Power-up Test Failure
Garmin G900X Pilot's Guide
HAZARD AVOIDANCE
Description
463