Garmin G900X Pilot's Manual page 430

HAZARD AVOIDANCE
Sector Scan:
1) While in horizontal scan mode, press the BRG Softkey to display the Bearing Line and place the cursor in the
BEARING field. If the Bearing Line is not displayed, press the MENU Key and turn the large FMS Knob to select
Show Bearing Line.
2) Press the ENT Key.
3) Turn the small FMS Knob to place the Bearing Line in the desired position. The location of the Bearing Line
becomes the center point of the Sector Scan.
4) Turn the large FMS Knob to place the cursor in the SECTOR SCAN field.
5) Turn the small FMS Knob to select FULL, 60˚, 40˚, or 20˚ scan.
6) If desired, readjust the Bearing Line as discussed previously to change the center of the Sector Scan.
7) Press the BRG Softkey again to remove the Bearing Line and cursor. The bearing reference resets to 0º.
414
Figure 6-109 Selecting Sector Scan Position
Garmin G900X Pilot's Guide
190-00726-00 Rev. J