Ident Function - Garmin G900X Pilot's Manual

AUDIO PANEL AND CNS
If an error is made during code entry with the numeric keypad, press the BKSP Key to move the cursor
back one space. If an incorrect code is entered, reenter the correct one using the same procedure.
Third, Press ENT Key to
Complete Code Entry
VFR CODE
Press the XPDR Softkey, then the VFR Softkey to display the pre-programmed VFR code in the code field of
the Transponder Data Box. Press the VFR Softkey again to restore the previous identification code.
The pre-programmed VFR Code is set at the factory to 1200. If a VFR code change is required, contact a
Garmin-authorized service center for configuration.

IDENT FUNCTION

In Standby Mode, the IDENT Softkey is inoperative.
NOTE:
Press the IDENT Softkey to send a distinct identity indication to Air Traffic Control (ATC). The indication
distinguishes the identing transponder from all the others on the air traffic controller' s screen. The IDENT
Softkey appears on all levels of transponder softkeys. When the IDENT Softkey is pressed, a green IDNT
indication is displayed in the mode field of the Transponder Data Box for a duration of 18 seconds.
After the IDENT Softkey is pressed while in Mode or Code Selection, the system reverts to the top-level
softkeys.
166
Second, Turn the FMS Knob, Small
Knob to Enter Two Code Digits at a
Time, Large Knob to Move the Cursor
to the Next Code Field, or Press the
Numeric Keys to Enter a Code into the
Transponder Data Box
First, Press the XPDR Key to
Activate Code Entry from the
FMS Knob or Numeric Keypad
into the Transponder Data Box
Figure 4-45 Transponder Code Entry from the Control Unit
Figure 4-46 VFR Code
Garmin G900X Pilot's Guide
VFR Code
190-00726-00 Rev. J