Procedure; Configure Switch Parameters Dialog Box - HP 316095-B21 - StorageWorks Edge Switch 2/24 User Manual

Procedure

To configure switch operating parameters:
1. The switch must be offline to change the Preferred Domain ID. If it is not, and you
activate values in this dialog box,you are prompted to set the unit offline.
CAUTION: Setting the switch offline terminates all Fibre Channel connections.
To set the unit offline:
a. From the Product Manager window menu bar, select Maintenance > Set
Online State.
b. When the Set Online State dialog box displays, click Set Offline.
c. When the warning box displays asking to confirm the offline state, click OK.
2. Select Configure > Operating Parameters > Switch Parameters.
The Configure Switch Parameters dialog box displays.
Figure 3–2: Configure Switch Parameters dialog box
NOTE: Ordinarily, you do not need to change values in this dialog box from their defaults. The
only exception is the Preferred Domain ID. Change this value if the switch will participate in a
multi-switch fabric.
3. Use the information described earlier in this section to change settings as required
for parameters in this dialog box.
4. After you change settings, click the Activate button.
5. Set the switch online:
a. Select Set Online State from the Maintenance menu on the menu bar.
b. When the Set Online State dialog box displays, click the Set Online button.
edge switch 2/24 product manager user guide
Configuring the Switch
3–5