Modify An Alert - HP 316095-B21 - StorageWorks Edge Switch 2/24 User Manual

Modify an Alert

Use the following steps to modify an existing threshold alert configuration.
1. Select Threshold Alerts from the Configure menu.
The Configure Threshold Alerts dialog box displays.
2. Select the alert that you want to modify by clicking the alert information in the
table.
3. If the alert is active, select Deactivate, then select the alert information in the table
again.
4. Select Modify.
NOTE: If the alert is active, an error message displays prompting you deactivate the alert.
An initial Modify Threshold screen appears where you can change the threshold
type.
5. Select a threshold type from the drop-down list.
6. Select Next when you are done. A Modify Threshold screen appears where you
can change the % utilization, cumulative minutes for the threshold to occur before
notification, and the time interval for measuring throughput and for alert
notification.
7. Continue through the Modify Threshold screens until the summary screen
appears displaying the alert configuration.
8. Perform either of the following steps:
— If you need to change any parameters, select Previous and Next to display the
desired Modify Threshold screen.
— Select Finish when you are done.
edge switch 2/24 product manager user guide
Configuring the Switch
3–25