HP 316095-B21 - StorageWorks Edge Switch 2/24 User Manual page 161

Table A–1: StorageWorks Edge Switch 2/24 Product Manager Messages (Continued)
Message
Non-redundant switch must
be offline to install firmware.
Not all of the optical
transceivers are installed for
this range of ports.
Performing this operation
will change the current state
to Offline.
Performing this operation
will change the current state
to Online.
Performing this action will
overwrite the date/time on
the switch.
Periodic Date/Time
synchronization must be
cleared before enabling
switch clock alert.
Port binding was removed
from attached devices that
are also participating in
Switch Binding.
edge switch 2/24 product manager user guide
Description
Since the switch has only a
single CTP card, it must be
offline to initiate a firmware
installation. Note that the
CTP card is an internal
component and not a FRU.
Some ports in the specified
range do not have optical
transceivers installed.
This operation causes the
switch to go offline.
This operation causes the
switch to go online.
Warning that occurs when
configuring the date and
time through the Configure
Date and Time dialog box,
that the new time or date will
overwrite the existing time or
date set for the switch.
Action cannot be performed
because Periodic Date/Time
Synchronization option is
active.
Informational message.
User has removed Port
Binding from attached
devices, but one or more of
these devices is still
controlled by Fabric Binding.
Product Manager Messages
Action
Take switch offline and try
again.
Use a port range that is valid
for the ports installed.
N/A. An informational
message.
N/A. An informational
message.
Verify that you want to
overwrite the current date or
time.
Click Periodic Date/Time
Synchronization check box
in Configure Date and Time
dialog box (Configure menu)
to clear check mark and
disable periodic date/time
synchronization.
Review the Switch Binding
Membership List to
determine if the devices
should be members.
A–11