Procedure; Configure Identification Dialog Box - HP 316095-B21 - StorageWorks Edge Switch 2/24 User Manual

Configuring the Switch

Procedure

To configure identification for the switch, use the following steps:
1. From the menu bar, select Configuration > Identification.
The Configure Identification dialog box displays.
Figure 3–1: Configure Identification dialog box
2. Click in the name field and enter a name for the switch. The name could reflect the
switch's Ethernet network domain name service (DNS) host name, if assigned.
3. Click in the Description field and enter a description of the switch.
4. Click in the Location field and enter the location of the switch.
5. Click in the Contact field and enter appropriate information about a contact
person, such as a phone number, title, or e-mail address.
6. Click Set Name as Nickname and add a check mark to the check box if you want
to use the name in the Name field as a nickname for the switch's WWN. The
nickname will then display instead of the WWN in Product Manager views.
7. Click Activate to save the data and close the dialog box.
8. If you are finished configuring the switch, back up the configuration data. For
more information, refer to
3–2
Backup and Restore Configuration on page
edge switch 2/24 product manager user guide
5–6.