HP 316095-B21 - StorageWorks Edge Switch 2/24 User Manual page 32

Product Manager Overview
Configure Menu
Click on the Configure menu on the menu bar to display the following options. For
detailed information on using these options, refer to
Switch.
Identification
Select this option to display the Configure Identification dialog box. Enter the
following information in this dialog box:
— Name - Assign a product name. Note that you can set this name as the
nickname for the switch's WWN, using the Set Name as Nickname
checkbox. The nickname then displays instead of the WWN in Product
Manager views.
— Description - Assign a unique product description.
— Location - Describe the product's location.
— Contact - Assign a contact either by name, phone number, or e-mail address.
NOTE: This information displays in the identification table at the top of the Hardware View and
in the HAFM Product View, if the Product View is configured to display names.
Switch Operating Parameters
Use this dialog box to set parameters on the switch for fabric operation. Set other
fabric operating parameters, such as preferred domain ID (1 to 31) and Domain
RSCNs. In addition, you can also enable the rerouting delay feature. Refer to
Configure Switch Operating Parameters on page 3-3
configuring the switch priority and rerouting delay.
Fabric Operating Parameters
Use this dialog box to set parameters for fabric operation. In this dialog box, you
can set the resource allocation time-out value (R_A_TOV) and error detect
time-out value (E_D_TOV) in tenth-of-a-second increments, as well as other
fabric operating parameters, such as switch priority level (Principal, Default, or
Never Principal) and interop mode. You must take the switch offline through the
Set Online State dialog box to configure these parameters. Refer to
Fabric Operating Parameters on page 3-6
1–16
Chapter 3, Configuring the
for more information on
for more information.
edge switch 2/24 product manager user guide
Configure