HP 316095-B21 - StorageWorks Edge Switch 2/24 User Manual page 163

Table A–1: StorageWorks Edge Switch 2/24 Product Manager Messages (Continued)
Message
Stop diagnostics failed. The
test is already running.
Stop diagnostics failed. The
test was not running.
Switch Binding was
removed from attached
devices that are also
participating in Port Binding.
Please review the Port
Binding Configuration.
System diagnostics cannot
run. The Operational Status
is invalid.
The add firmware process
has been aborted.
The data collection process
failed.
The data collection process
has been aborted.
The following parameters
cannot be disabled while
Enterprise Fabric Mode is
active: Insistent Domain ID,
Rerouting Delay, Domain
RSCN's.
The firmware file is
corrupted.
edge switch 2/24 product manager user guide
Description
Diagnostics for the port was
not running and the Stop
was selected on the Port
Diagnostics dialog box.
Diagnostics quit for the port
for some reason, but the
Stop button remains
enabled.
The action to stop
diagnostics failed because
the test was not running.
The device WWNs were
removed from the Switch
Membership List
(SANtegrity Switch Binding
feature), but you should note
that one or more of these
devices still has security
control in port binding.
System diagnostics cannot
run on switches with failed
ports.
User has ended the add
firmware process.
An error occurred in the data
collection process.
User has ended the data
collection process.
User attempted to disable
these parameters in the
Configure Switch
Parameters dialog box while
Enterprise Fabric Mode is
enabled.
A firmware file has corrupt
data.
Product Manager Messages
Action
Verify port operation. Retry
diagnostics for port and
select Stop from the dialog
box. If problem persists,
contact your service
representative.
Informational message.
Verify that the security level
for each device is as
required by reviewing the
Bound WWN list in the
Configure Ports dialog box.
Replace failed ports.
N/A. An informational
message.
Contact support personnel.
N/A. An informational
message.
Disable Enterprise Fabric
Mode through the
Enterprise Fabric Mode
dialog box in the HAFM,
then disable the parameters.
Contact support personnel.
A–13