Installing The M120 Air Filter; Figure 67: Removing The M120 Air Filter - Juniper M120 Hardware Manual

Copyright © 2010, Juniper Networks, Inc.

Figure 67: Removing the M120 Air Filter

Installing the M120 Air Filter

To install the front air filter (see Figure 68 on page 140):
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Insert the air filter element into the chassis by sliding it straight into the chassis until
2.
it stops.
While pushing the air filter straight back into the chassis, lift the front edge of the air
3.
filter to secure it under the hooks.
Reinstall the air filter faceplate onto the chassis, and fasten the captive screws on
4.
both sides.
Lower the cable management system back into position.
5.
Rearrange the PIC cables in the cable management system. For more information
6.
about proper cable arrangement, see "Maintaining M120 PICs and PIC Cables" on
page 112.
Chapter 14: Replacing M120 Hardware Components
139