Juniper M120 Hardware Manual page 186

M120 Multiservice Edge Router Hardware Guide
158
For more information about the command, see the Junos OS System Basics and
Services Command Reference.
Remove the cable from the transceiver on the CFPC faceplate.
4.
Pull the lower end of the ejector lever away from the CFPC faceplate to unseat the
5.
CFPC.
Continue to pull the lever toward you and slide the CFPC straight out of the card cage
6.
halfway.
Place one hand around the front of the CFPC and the other hand under it to support
7.
it. Slide the CFPC completely out of the chassis, and place it on the antistatic mat or
in the electrostatic bag.
CAUTION: When the CFPC is out of the chassis, do not hold it by the ejector
handle, bus bars, or edge connectors. They cannot support its weight.
Place each individual CFPC in an individual electrostatic bag or on its own
antistatic mat on a flat, stable surface.
If you are not reinstalling a CFPC into the emptied CFPC slot within a short time, install
8.
a blank CFPC panel over the slot to maintain proper airflow within the router.
CAUTION: After removing a CFPC from the chassis, wait at least 30
seconds before reinserting it, removing a CFPC from a different slot, or
inserting a CFPC into a different slot.
Copyright © 2010, Juniper Networks, Inc.