Figure 82: Installing An M120 Pic - Juniper M120 Hardware Manual

M120 Multiservice Edge Router Hardware Guide
164
CAUTION: Avoid bending fiber-optic cable beyond its minimum bend
radius. An arc smaller than a few inches in diameter can damage the cable
and cause problems that are difficult to diagnose.
Use one of the following methods to bring the PIC online:
8.
Press and hold the PIC offline button until the status LED on the PIC faceplate
indicates normal functioning, which usually takes about 5 seconds. The LED is
usually green; for more information, see the MX Series 3D Universal Edge Routers
Line Card Guide. For the PICs that install on an FPC1, the offline button for each PIC
is next to it on the FPC card carrier. For the PICs that install on an FPC2 or FPC3, the
offline button is on the PIC faceplate.
Issue the CLI command:
user@host> request chassis pic fpc-slot fpc-slot pic-slot pic-slot online
For more information about the command, see the Junos OS System Basics and
Services Command Reference.
The normal functioning status LED confirms that the PIC is online. You can also verify
correct PIC functioning by issuing the
in "Maintaining M120 PICs and PIC Cables" on page 112.

Figure 82: Installing an M120 PIC

show chassis fpc pic-status
Copyright © 2010, Juniper Networks, Inc.
command described