Tools And Parts Required To Unpack The M120 Router; Unpacking The M120 Router - Juniper M120 Hardware Manual

M120 Multiservice Edge Router Hardware Guide
Related
Documentation

Tools and Parts Required to Unpack the M120 Router

Related
Documentation

Unpacking the M120 Router

44
See "Connecting the Grounding Cable to the M120 Router" on page 79.
Connect the AC power cord or DC power cables:
8.
Connecting Power to an AC-Powered M120 Router on page 89
Connecting Power to a DC-Powered M120 Router on page 91
Power on the router.
9.
See "Powering On the M120 Router" on page 92.
Perform the initial system configuration.
10.
See "Initially Configuring JUNOS Software on the M120 Router" on page 95.
M120 Router Chassis Description on page 6
Installation Safety Warnings for M Series, MX Series, and T Series Routers on page 195
M120 Chassis Lifting Guidelines on page 195
To unpack the router and prepare for installation, you need:
Phillips (+) screwdriver, number 2
1/2-in. or 13-mm open-end or socket wrench to remove bracket bolts from the shipping
pallet
Blank panels to cover any slots not occupied by a component
M120 Router Chassis Description on page 6
M120 Router Installation Summary on page 43
M120 Site Preparation Checklist on page 37
The router is shipped in a cardboard box strapped securely to a wood pallet. Plastic
straps secure the top and bottom in place. The router chassis is bolted to this pallet.
Quick Start installation instructions and a cardboard accessory box are also included in
the shipping container.
The shipping container measures 32.5 in. (82.6 cm) high, 35 in. (88.9 cm) wide, and
27 in. (68.6 cm) deep. The total weight of the container containing the router and
accessories can range from 149 lb (63.5 kg) to 280 lb (127 kg).
NOTE: The router is maximally protected inside the shipping crate. Do not
unpack it until you are ready to begin installation.
Copyright © 2010, Juniper Networks, Inc.