Upgrade And Downgrade Instructions For Junos Os Release 10.4 For M Series, Mx Series, And T Series Routers - Juniper JUNOS OS 10.4 - RELEASE NOTES Release Note

JUNOS OS 10.4 Release Notes
Related
Documentation
Upgrade and Downgrade Instructions for Junos OS Release 10.4 for M Series, MX Series, and T
Series Routers
70
[Subscriber Access]
The Subscriber Access Configuration Guide incorrectly describes the
statement as it is used for subscriber access management. When configuring the
authentication-order statement for subscriber access management, you must always
specify the method. Subscriber access management does not support the
radius
keyword (the default), and authentication fails when you do not specify an
password
authentication method.
[Subscriber Access]
User Interface and Configuration
The show system statistics bridge
routers. [System Basics Command Reference]
VPNs
In Chapter 19, Configuring VPLS of the VPNs Configuration Guide, an incorrect statement
that caused contradictory information about which platforms support LDP BGP
interworking has been removed. The M7i router was also omitted from the list of
supported platforms. The M7i router does support LDP BGP interworking.
[VPNs]
New Features in Junos OS Release 10.4 for M Series, MX Series, and T Series Routers
on page 6
Changes in Default Behavior and Syntax in Junos OS Release 10.4 for M Series, MX
Series, and T Series Routers on page 37
Issues in Junos OS Release 10.4 for M Series, MX Series, and T Series Routers on page 48
Upgrade and Downgrade Instructions for Junos OS Release 10.4 for M Series, MX Series,
and T Series Routers on page 70
Upgrade and Downgrade Instructions for Junos OS Release 10.4 for M Series, MX Series,
and T Series Routers on page 70
This section discusses the following topics:
Basic Procedure for Upgrading to Release 10.4 on page 71
Upgrading a Router with Redundant Routing Engines on page 73
Upgrading Juniper Network Routers Running Draft-Rosen Multicast VPN to Junos OS
Release 10.1 on page 73
Upgrading the Software for a Routing Matrix on page 75
Upgrading Using ISSU on page 76
Upgrading from Junos OS Release 9.2 or Earlier on a Router Enabled for Both PIM and
NSR on page 76
command displays system statistics on MX Series
Copyright © 2010, Juniper Networks, Inc.
authentication-order