Juniper JUNOS OS 10.4 - RELEASE NOTES Release Note page 57

Copyright © 2010, Juniper Networks, Inc.
Issues in Junos OS Release 10.4 for M Series, MX Series, and T Series Routers
High Availability
On M120 routers, the message: "stream blocked detected message" displays when an
FEB is switched from the backup to the primary. [PR/540644: This issue has been
resolved.]
Interfaces and Chassis
The output of the monitor interface interface-name
This issue has been resolved.]
An OAM trace displays an incorrect next-hop MAC value. [PR/494588: This issue has
been resolved.]
When traffic flows into the MPC on which a bridge-domain configuration is being
changed or the card is booting up, the forwarding software tries to access uninitialized
memory for a short duration. This is a cosmetic issue and does not have any functional
impact. [PR/506344: This issue has been resolved.]
On M7i routers with Junos OS Release 8.5 or later, the output of the
command shows the fxp0 interface to be in the link up state even when the
fxp0
interface is disabled with no cables connected. [PR/508261: This issue has been
resolved.]
When the VRRP6 master changes, there is no log output for VRRP IPv6. [PR/514821:
This issue has been resolved.]
When the PIC is configured with encapsulation atm-ccc-cell-relay psuedowires, and
the PIC throughput exceeds 152 Mbps, data loss occurs and the following error message
is displayed: "[Warning] ce_wp_poll_hspi_stats:2006: PF/Winpath SPI interface error,
rx_err_sm 243." This error message is not seen when encapsulation atm-ccc-vc-mux
is used.
As a workaround, use the atm-ccc-vc-mux encapsulation (AAL5 ATM PW), or use
atm-ccc-cell-relay and configure a larger cell bundle size. When the cell bundle size
is 5, the PIC passes 190 Mbps without error. [PR/515632: This issue has been resolved.]
When a SIB is taken offline via a CLI command, the output of the
command does not display the message "Offlined by cli command." However, this
message is correctly displayed for the FPCs. [PR/519842: This issue has been resolved.]
The statistics get for LSQ interfaces fails in a scaled LSQ configuration when the
interfaces queue lsq-w/x/y:z
resolved.]
When MLPPP interfaces of an MS-PIC are taken offline, the following syslog message
displays: "RT: itable unset idx 372 to proto MLPPP iftable failed (Invalid arguments)
on FE -1." [PR/528649: This issue has been resolved.]
In Junos OS Release 10.0 and later, a significantly large number of the following
messages appear on the MX960 and SRX5800 routers:
MX960 /kernel: PCF8584(WR): transmit failure on byte 1
MX960 /kernel: PCF8584(WR): (i2c_s1=0x80, group=0xe, device=0x54)
MX960 /kernel: PCF8584(WR): busy at start, attempting to clear
MX960 /kernel: PCF8584(WR): (i2c_s1=0x00, group=0xe, device=0x54)
command is misaligned. [PR/70077:
command is executed. [PR/523260: This issue has been
show interfaces
show chassis sibs
show
57