Junos Os Xml Api And Scripting - Juniper JUNOS OS 10.4 - RELEASE NOTES Release Note

Changes in Default Behavior and Syntax in Junos OS Release 10.4 for M Series, MX Series, and T Series Routers
Copyright © 2010, Juniper Networks, Inc.
Support for configuring shaping overhead—Support for CLI based configuration of
shaping overhead has been added to the PD-5-10XGE-SFPP Type 4 PIC.
Set bandwidth value on aggregated Ethernet interfaces—You can now set the
bandwidth value by using the
aggregate-interface unit number]
Additionally, the
show interfaces aggregate-inteface extensive
aggregate.logical-interface
it is configured. Also, the SNMP OID ifSpeed/ifHighSpeed of the aggregate logical
interface shows the corresponding bandwidth, when it is configured. When it is not
configured, the command shows it as the sum of the bandwidths of the member links
of the aggregate, as before.
Network interfaces
show
interfaces detail / extensive
truncated) names of the forwarding classes associated with queues.
[Network Interfaces]
Negotiate IP address option removed—The negotiate IP address option is no longer
allowed in the MLFR and MFR encapsulations.
Hardware restrictions in the output of the show interfaces extensive command
using the
show interfaces extensive
"Filter statistics" section will not be displayed because the hardware does not include
those counters.
Increase in unit numbering for demux0 and pp0 interfaces—The unit numbering for
demux0 and pp0 interfaces has been increased to 1,073,741,823.
Show chassis environment cb
command is now available for the MX80 routers.
environment cb

Junos OS XML API and Scripting

The
jcs:load-configuration
jcs:load-configuration template, included in the import file
parameter to customize the
$commit-options
be passed to the
jcs:load-configuration
The default value for
$commit-options
—Check the correctness of the candidate configuration syntax, but do not
check
commit the changes.
—Force the commit on the other Routing Engine (ignore any
force-synchronize
warnings).
—Write the specified message to the commit log. This is identical to the CLI
log
configuration mode command
—Synchronize the commit on both Routing Engines.
synchronize
statement at the
bandwidth value
hierarchy level.
commands now show the bandwidth of the aggregate when
command output (All platforms)—The output of the
command now adds a table that shows complete (not
command with a 100-Gigabit Ethernet PIC, the
command on MX80 routers—The
template now accepts the
commit
template as a node-set.
is null. Supported options are:
.
commit comment
[edit interfaces
and the
show interfaces
—When
show chassis
parameter—The
$commit-options
junos.xsl , now accepts the
operation. The parameter must
show
39