Juniper JUNOS OS 10.4 - RELEASE NOTES Release Note page 164

JUNOS OS 10.4 Release Notes
164
On SRX210, SRX220, and SRX240 devices with voice capability, when a call came to
an SRX Foreign Exchange Office (FXO) and was forwarded to a PCS, the caller ID was
not preserved. [PR/535540: This issue has been resolved.]
On SRX240 devices with voice capability, the voice prompts did not play for all E911
pre-emption calls. [PR/537554: This issue has been resolved.]
On SRX210 and SRX240 devices with voice capability, E911 pre-emption did not happen
when the PSTN line was busy in the ringing state. [PR/538277: This issue has been
resolved.]
On SRX5800 devices, where there were a large number of zones using the same screen,
you could see some zones not passing traffic across. [PR/526082: This issue has been
resolved.]
Interfaces and Routing
On SRX210 devices, the G.SHDSL ATM logical interface went down when ATM CoS
was enabled on the interface with OAM. [PR/472198: This issue has been resolved.]
On SRX240 and J4350 devices, MAC address changes for the VLAN interface were
not supported. [PR/518934: This issue has been resolved.]
On SRX3400, SRX3600, SRX5600, and SRX5800 devices, sometimes CPU utilization
was 100 percent on Web management. [PR/527344: This issue has been resolved.]
On J4350 devices, PIM RPT to PIM SPT switchover did not occur when downstream
interfaces were configured with IGMP and MLD. [PR/524950: This issue has been
resolved.]
Intrusion Detection and Prevention (IDP)
On SRX3400 devices, the packet-logging functionality was not supported in
dedicated-equal mode. All other modes of operation were supported. [PR/526252:
This issue has been resolved.]
On SRX650 Series devices, IDP detector and/or IDP attack database update caused
chassis cluster instability and the secondary node could go to disabled state.
[PR/523494: This issue has been resolved.]
J-Web
On SRX Series devices, the J-Web application screen listing was not sorted correctly
for the port column. [PR/521962: This issue has been resolved.]
On SRX100, SRX210, SRX220, SRX240, and SRX650 devices, configuring NAT traversal
(NAT-T) for IKE Gateway in J-Web did not reflect properly. [PR/527151: This issue has
been resolved.]
On SRX100, SRX210, SRX220, and SRX240 devices, the J-Web setup wizard did not
work in IE. [PR/536027: This issue has been resolved.]
Copyright © 2010, Juniper Networks, Inc.