Juniper JUNOS OS 10.4 - RELEASE NOTES Release Note page 152

JUNOS OS 10.4 Release Notes
152
On SRX100, SRX210, and J Series devices, out-of-band dial-in access using a serial
modem does not work. [PR/458114]
On SRX100 and SRX200 devices with VDLS2, multiple carrier transitions (three to
four) are seen during long-duration traffic testing with the ALU 7302 DSLAM. There is
no impact on traffic except for the packet loss after long-duration traffic testing, which
is also seen in the vendor CPE. [PR/467912]
On SRX210 devices with VDLS2, the remote end ping operation fails to go above the
packet size of 1480 because the packets are dropped for the default MTU, which is
1496 on an interface, and because the default MTU of the remote host Ethernet
interface is 1514. [PR/469651]
On SRX3400, SRX3600, SRX5600, and SRX5800 devices, the
counter command gives error messages from the secondary node. [PR/477017]
On SRX3400, SRX3600, SRX5600, and SRX5800 devices, when you change the
multicast scoping to a different multicast address, traffic other than which is configured
for multicast scoping is not received. [PR/482957]
On all SRX Series devices, the destination and destination-profile options for address
and unnumbered-address within family inet and inet6 are allowed to be specified
within a dynamic profile but are not supported. [PR/493279]
On SRX210 High Memory devices, the physical interface module (PIM) shows time in
ADSL2+ ANNEX-M, even though it is configured for ANNEX-M ADSL2. [PR/497129]
On SRX100, SRX210, SRX240, and SRX650 devices, whenever
configured under the
profile
radius times out. As a workaround, configure
under the option. [PR/503717]
access
On SRX5600 and SRX5800 devices, load balance does not happen within the
aggregated Ethernet (ae)
incrementing the dst ip. [PR/505840]
On SRX100, SRX210, SRX240, and SRX650 devices, egress queues do not function
on VLAN or IRB interfaces. [PR/510568]
On SRX650 devices, in the 2-port 10G XPIM, when the interface is linked with fiber, the
activity LED does not blink when traffic enters the interface. However, the activity LED
blinks properly when traffic goes out of the interface. [PR/513961]
On SRX3400, SRX3600, SRX5600, and SRX5800 devices, if stress FTP traffic is
sustained for several minutes, the device might begin to accept only limited new FTP
connections. This situation might continue for one minute, and then the the device
returns to normal functioning. [PR/530142]
On SRX240 and SRX650 devices, IGMP reports are flooded on all ports that are part
of the same multicast group instead of being sent on only the router interface.
[PR/546444]
On SRX650 devices, the speed for the
the negotiated speed. [PR/553339]
option, radius server is marked as dead permanently if
radius-server
interface when you prefix the length with /24 while
interface shows the interface speed and not
ae
show datapath-debug
is
radius-server
outside the option
profile
Copyright © 2010, Juniper Networks, Inc.