Command-Line Interface (Cli) - Juniper JUNOS OS 10.4 - RELEASE NOTES Release Note

JUNOS OS 10.4 Release Notes
134
Group VPN is not supported.
Sampling features like J-FLow, packet capture, and port mirror on the
are not supported.
IDP is not supported for active/active chassis cluster. IDP is supported for
active/backup chassis cluster in Junos OS Release 10.2R2 and later.
Switching is not supported in chassis cluster mode.
Any packet-based services like MPLS and CLNS are not supported.
lsq-0/0/0—Link services Multilink Point-to-Point Protocol (MLPPP), Multilink Frame
Relay (MLFR), and Compressed Real-Time Transport Protocol (CRTP) are not
supported.
gr-0/0/0—Generic routing encapsulation (GRE) and tunneling are not supported.
ip-0/0/0—IP-over-IP (IP-IP) encapsulation are not supported.
lt-0/0/0—CoS for real-time performance monitoring (RPM) are not supported.
PP0: PPPoE, PPPoEoA is not supported.
ISDN/WXC are not supported in standalone mode.
On SRX100, SRX210, SRX220, SRX240, and SRX650 devices, UTM is supported only
for active/backup chassis cluster configuration with both RG0 and RG1 active on the
same node. It is not supported for active/active chassis cluster configuration.
For other limitations in chassis cluster, see "Limitations of Chassis Clustering" in the Junos
OS Security Configuration Guide.

Command-Line Interface (CLI)

On SRX210 and SRX240 devices, J-Web crashes if more than nine users log in to the
device by using the CLI. The number of users allowed to access the device is limited
as follows:
For SRX210 devices: four CLI users and three J-Web users
For SRX240 devices: six CLI users and five J-Web users
On SRX210 devices with Integrated Convergence Services, TDM configuration change
might interrupt existing TDM calls. The voice calls do not work. Run the CLI
command after making a configuration change.
interface
reth
restart rtmd
Copyright © 2010, Juniper Networks, Inc.