Juniper JUNOS OS 10.4 - RELEASE NOTES Release Note page 50

JUNOS OS 10.4 Release Notes
50
When the
show interfaces
is displayed. This information is visible under the interfaces hierarchy (configuration).
[PR/541574]
On a DPCE 20x 1 Gigabit Ethernet and 2x 10 Gigabit Ethernet, the link status of the
interface goes down when the TX router towards the peer is removed. [PR/542668]
When a member link is added to an existing aggregated interface, a multicast
distribution tree (MDT) mismatch might occur among the FPCs. This issue occurs only
when graceful Routing Engine switchover (GRES) is enabled. [PR/558745]
If the cable of a TX router is removed from the interface on an MIC-3D-20GE-SFP, the
state of the interface remains in the "up up" state. [PR/561254]
Under certain circumstances, the ping request to a VRRP master address is not
successful even when the
with an IRB interface. However, after the MAC aging timer expires, the ping request is
successful. [PR/565147]
A Layer 2 instability and rapid VRRP mastership change might cause
MPC-3D-16XGE-SFPP to restart. [PR/560716]
Layer 2 Ethernet Services
The release message is not sent to the DHCP server even though the
flag is set under the DHCP relay configuration. As a workaround,
send-release-on-delete
to deactivate or deconfigure an interface, clear all the bindings on the interface before
you deactivate or delete the interface. To deactivate or deconfigure the relay, clear all
the bindings before you deactivate or delete the relay. [PR/498920]
The PIM neighborship does not appear over the IRB interface after the dense port
concentrator (DPC) is restarted. [PR/559101]
command is used, no service set attachment information
accept-data option is configured on a VRRP group associated
Copyright © 2010, Juniper Networks, Inc.