Installation; Integrated Convergence Services; Interfaces And Routing - Juniper JUNOS OS 10.4 - RELEASE NOTES Release Note

Changes in Default Behavior and Syntax in Junos OS Release 10.4 for SRX Series Services Gateways and J Series Services Routers
Copyright © 2010, Juniper Networks, Inc.
Remove
multilink-max-classes
Remove
link-layer-overhead
If the LFI forwarding class is mapped to
the configuration hierarchy is enabled on
Add interleave-fragments
Adjust classifier configured for LFI on
packets to Q2
If the aforementioned instructions are not followed, the bundle will be incorrectly
processed.
On SRX Series devices, as per the new behavior, on configuring identical IPs on a single
interface users no longer see a warning message; instead, a syslog message appears.
On SRX5600 devices, when an authentication policy is being matched by traffic,
deleting the authentication configuration from this policy might cause a crash.

Installation

On SRX100, SRX210, SRX220, SRX240, and SRX650 devices, support for USB
auto-installation is added. This feature simplifies the upgrading of Junos OS images
in cases where there is no console access to an SRX Series device located at a remote
site. This feature allows you to upgrade the Junos OS image with minimum configuration
effort by simply inserting a USB flash drive into the USB port of the SRX Series device
and performing a few simple steps. This feature can also be used for reformatting boot
devices and recovering SRX Series devices after a boot media corruption.

Integrated Convergence Services

On SRX210 device with Integrated Convergence Services, users cannot clone the
existing configuration for Integrated Convergence Services. The clone option has been
removed from all Convergence Services pages on J-Web.

Interfaces and Routing

On SRX100, SRX210, SRX220, SRX240, and SRX650 devices, support for USB
auto-installation is added.
On SRX Series devices, to minimize the size of system logs, the default logging level
in the factory configuration has been changed from
On SRX3000 and SRX5000 line devices, the
routing-options flow CLI statements are no longer available, because BGP flow spec
functionality is not supported on these devices.
On SRX100, SRX210, SRX240, and SRX650 devices, the autoinstallation functionality
on an interface enables a DHCP client on the interface and remains in the DHCP client
mode. In previous releases, after a certain period, the interface changed from being a
DHCP client to a DHCP server.
from , if configured.
[ls-0/0/0 unit 0]
from , if configured.
[ls-0/0/0 unit 0]
no-fragmentation
in Junos OS Release 10.4, then
lsq-0/0/0
under [ls-0/0/0 unit 0]
under
lsq-0/0/0
any any
set protocols bgp family inet flow
in and
fragmentation-map
to classify
[class-of-service]
to .
any critical
and
set
117