NETGEAR DGND3300v2 - RangeMax Dual Band Wireless-N Modem Router User Manual page 84

a. Run the NETGEAR ProSafe Security Policy Editor program, and, using the
page 80, create a VPN connection.
b. From the Edit menu of the Security Policy Editor, select Add, and then click
Connection.
A New Connection listing appears in the list of policies.
c. Rename the new connection so that it matches the Connection Name field in the
VPN Settings screen of the N300 wireless modem router on LAN A. Choose
connection names that make sense to the people using and administering the VPN.
Note: In this example, the connection name used on the client side of the
VPN tunnel is togw_a, and it does not have to match the
RoadWarrior connection name used on the gateway side of the VPN
tunnel because connection names are irrelevant to how the VPN
tunnel functions.
d. Enter the following settings:
• Connection Security. Select Secure.
• ID Type. Select IP Subnet.
• Subnet. In this example, type 192.168.3.1 as the network address of the N300
wireless modem router.
• Mask. Enter 255.255.255.0 as the LAN subnet mask of the N300 wireless modem
router.
• Protocol. Select All to allow all traffic through the VPN tunnel.
e. Select the Connect using Secure Gateway Tunnel check box.
f. In the ID Type drop-down list, select IP Address.
84 | Chapter 6. Virtual Private Networking
N300 Wireless Dual Band ADSL2+ Modem Router DGND3300v2 User Manual
Table 3 on