Setting Up A Repeater Unit - NETGEAR DGND3300v2 - RangeMax Dual Band Wireless-N Modem Router User Manual

Figure 68.
3. Select the Enable Wireless Repeating Function check box and the Wireless Base
Station radio button.
4. Enter the MAC address for the repeater units.
5. Click Apply to save your changes.

Setting Up a Repeater Unit

Use a wired Ethernet connection to set up the repeater unit to avoid conflicts with the wireless
connection to the base station.
Note: If you are using the N300 Wireless Dual Band ADSL2+ Modem
Router DGND3300v2 base station with a non-NETGEAR N300
wireless modem router as the repeater, you might need to change
additional configuration settings. In particular, you should disable the
DHCP server function on the wireless repeater AP.
To configure a N300 wireless modem router as a repeater unit:
1. If you are using the same model of N300 wireless modem router for both the base
station and repeaters, you must change the LAN IP address for each repeater to a
different IP address in the same subnet (see
page 112).
Note: Failing to change the LAN IP address will cause an IP address
conflict in the network because the factory default LAN IP is the
same for both units.
128 | Chapter 7. Advanced Settings (Part 1)
N300 Wireless Dual Band ADSL2+ Modem Router DGND3300v2 User Manual
Using the LAN Setup Options on