Wireless Guest Networks - NETGEAR DGND3300v2 - RangeMax Dual Band Wireless-N Modem Router User Manual

Note: The SSID of any wireless access adapters must match the SSID
you configure in the N300 wireless modem router. If they do not
match, you will not get a wireless connection to the N300 wireless
modem router.
The Fragmentation Threshold, CTS/RTS Threshold, and Preamble Mode options are
reserved for wireless testing and advanced configuration only. Do not change these
settings.
• WPS Settings. These are Push 'N' connect settings used by the N300 wireless modem
router when WPS clients are added.
- Router's PIN. The number that the N300 wireless modem router broadcasts when
you add a WPS client with the PIN method.
- Disable Router PIN. Selecting this check box disables the N300 wireless modem
router's PIN.
- Keep Existing Wireless Settings. This check box is cleared by default so that the
N300 wireless modem router network name (SSID) and security can be set
automatically if Push 'N' Connect (WPS) is used to set up the network. When the first
WPS client is added, this check box is automatically selected so that the SSID and
security remain the same when additional clients are added.
For information about adding WPS clients, see
Configure Your Wireless Network
• Restricting access by MAC address. You can use the Wireless Card Access List to
restrict access. See

Wireless Guest Networks

A wireless guest network allows you to provide guests access to your wireless network
without prior authorization of each individual guest. You can configure wireless guest
networks and specify the security options for each wireless guest network.
The Guest Network Settings screen that you see depends on the setting in the Wireless
Mode field on the Wireless Settings screen and on which selection you make from the main
menu. The Guest Network selection is grayed out if it is not available. The following table
shows wireless modes, menu selections, and guest networks.
Mode in Wireless Settings
Screen
Up to 300 Mbps at 5 GHz & 54
Mbps at 2.4 GHz
(factory default setting)
30 | Chapter 2. Wireless Settings
N300 Wireless Dual Band ADSL2+ Modem Router DGND3300v2 User Manual
on page 24.
Restricting Access by MAC Address
Menu Selection
Guest Network a/n
Guest Network b/g
Using Push 'N' Connect (WPS) to
on page 35.
Guest Network Default SSID
NETGEAR-5G_a_n_Guest1
NETGEAR-2.4G_g_Guest1
Wireless
Compatibility
• 5GHz 802.11a
• 5GHz 802.11n
• 2.4GHz 802.11g
• 2.4GHz 802.11b