Setting Up Client-To-Gateway Vpn Configuration; Step 1: Configure Gateway A (Router At The Main Office) - NETGEAR N300 User Manual

Setting Up Client-to-Gateway VPN Configuration

Setting up a VPN between a remote PC running the NETGEAR ProSafe VPN Client and a
network gateway involves two steps:
•

Step 1: Configure Gateway A (Router at the Main Office)

• Step 2: Configure Gateway B (Router at the Regional Office)
configuring the NETGEAR ProSafe VPN Client endpoint.
Step 1: Configure Gateway A (Router at the Main Office)
1. Log in to the VPN router. Select VPN Policies to display the VPN Policies screen. Click
Add Auto Policy.
2. Enter the following information, based on your individual setup:
• Policy Name. In this example, from GW_A is used.
• IKE Keep Alive: This is optional. It has to match the value in the Remote LAN IP
Address field when enabled. (The remote computer has to respond to pings.)
• Remote LAN. In this example, the IP address is 192.168.2.3. The remote NAT router
has to have address reservation set and VPN Passthrough enabled.
• IKE Local Identity Type and Remote Identity Type. In this example, the fully
qualified domain names used are from GW_A.com and toGW_A.com.
N300 Wireless ADSL2+ Modem Router DGN2200v3
VPN Configuration
154
on page 154.
on page 155 describes