Setting Up A Repeater Unit - NETGEAR RangeMax WPN824v3 User Manual

RangeMax Wireless Router WPN824v3 User Manual
4. Enter the MAC address for the repeater units.
5. Click Apply to save your changes.

Setting Up a Repeater Unit

Use a wired Ethernet connection to set up the repeater unit to avoid conflicts with the wireless
connection to the base station.
Note: If you are using the Wireless Router Model WPN824v3 base station with a
different model wireless router as the repeater, you might need to change additional
configuration settings. In particular, you should disable the DHCP server function
on the wireless repeater AP.
To configure a Wireless Router Model WPN824v3 as a repeater unit:
1. If you are using the same model of wireless router for both the base station and repeaters, then
you must change the LAN IP address for each repeater to a different IP address in the same
subnet (see "Specifying LAN IP Settings" on page
Note: Failing to change the LAN IP address will cause an IP address conflict in the
network because the factory default LAN IP is the same for both units.
2. Check the Wireless Settings screen, and verify that the wireless settings match the base unit
exactly. The wireless security option must be set to WEP or None.
3. On the Wireless Repeating Function screen, select the Enable Wireless Repeating Function
check box.
In the Repeater IP Address field, the router's IP address is automatically filled in. This IP
address must be in the same subnet as the base station but different from the LAN IP of the
base station.
4. Fill in the Base Station MAC Address field.
5. Click Apply to save your changes.
6. Verify connectivity across the LANs.
A computer on any wireless or wired LAN segment of the wireless router should be able to
connect to the Internet or share files and printers with any other wireless or wired computer or
server connected to the other AP.
5-4
5-7).
v1.0, January 2008
Advanced Settings and Features